#Horizon treadmill troubleshooting series#
Horizon series (19 pages) Treadmill Horizon Fitness T900 User Manual. (47 pages) Treadmill Horizon Fitness HORIZON T83 User Manual. Horizon series treadmill (36 pages) Treadmill Horizon Fitness T82 Owner's Manual. Check that the console wiring is securely connected to the circuit board. Horizon series treadmill (37 pages) Treadmill Horizon Fitness T82 User Manual.Verify that there are no lights lit on the lower circuit board. CORRECTIVE ACTION: Reattach the connection securely if needed. Locate the male-female connection between the console and mast.Replace the console faceplate and replace the screws that hold the console electronics to the console housing.CORRECTIVE ACTION: Reattach cable securely if needed. Check that the console cable (a gray or black cable) is securely attached to the console circuit board.From the top of the console, gently lift the console faceplate and electronics from the console housing.Remove screws that hold the console electronics to the console housing.Wait 60 seconds, allowing lower board to discharge built up energy. But if youve ruled out user error and the treadmill still wont turn on or doesnt work correctly, your Horizon treadmill may have a mechanical malfunction. For easier adjustment bolt access, remove the end caps. If you find the belt is slipping because it is too loose, center it then tension as needed. Repeat if necessary, until the belt remains centered during use. Use the motor cover marking or part line as a reference for alignment. If the running belt is too far to the left side: Using the supplied Allen wrench and with the treadmill running at 1 mph turn the LEFT adjustment bolt clockwise a ¼ turn and wait for the belt to adjust itself. If the running belt is too far to the right side: Using the supplied Allen wrench and with the treadmill running at 1 mph turn the LEFT adjustment bolt counter-clockwise a ¼ turn and wait for the belt to adjust itself. TArGET ProfiLES TArGET 1 TiME: Allows user to set a target based on how long they would like to workout. 3) Stand on the side rails of the treadmill. 2) Plug in the power cord and turn the treadmill ON. Do not run belt faster than 1 mph and keep fingers, hair and clothing away from belt at all times. If the machine shuts down, there may be a problem with the motor, or the machine may have a faulty circuit. 1) Check to make sure no objects are placed on the belt that will hinder the movement of the treadmill. Resolution This issue can be resolved by aligning/centering and tensioning the running belt.
0 kommentar(er)
